FastECU

Is there a possibility to enable a full flash of the ecu contents?

For instance, even if values in the data block have not changed, still command them to be overwritten?

Hey Miika,

I attempted to read a 2018 USDM STI the other day. I was unable to get the read procedure to begin. Process immediately failed. Attempted after verifying EcuFlash would communicate both read and flash

Are you able to see if 2018+ is able to be supported?

Thank you

Yes, Denso CAN works as it should. I have not been able to successfully read any K-Line Roms other than stock roms. Is there a way to "Brute force" a read on the K-line? Currently attempting on A2ZJ710J which is a 512k rom, so that could be different from 1mb roms too?

Miika,

Do you have a flash method developed for Cobb K Line vehicles? I cannot seem to get FastEcu to read through K Line

Yes, I can email you some definitions to see what seems to be going on

I will try and find some time to attempt the denso bootloader, the car currently is flashed with the V2 AP. Just haven't found the time to sit down and change things recently

Miika,

Concerning definitions, maps that were previously shown with standard definitions are present and are displayed correctly. But all of the tables that I have added seem to populate under an unnamed category but do not translate the axis or map data. Please advise on what I need to do to get ...

Whoops...

Just saw the denso_can_recovery protocol

Hey there MiikaS

I've been playing around with FastECU a little bit recently and have some questions

Firstly, is it possible to have the software ignore the RomRaider definitions and work solely from EcuFlash definitions? I have been generating my own extended EF definitions and have not gotten ...